Statistical analysis of environmental parameters in continuous indentation tests using Taguchi method
Article Abstract:
The effects on the accuracy of indentation tensile properties and the optimum values of the number of unloadings and the unloading ratio, the maximum depth ratio and the indenter radius are analyzed quantitatively using the Taguchi method. The indentation parameters were found to vary with the experimental parameters and the optimum experimental parameters were determined, and confirmed, for evaluation of the indentation tensile properties.
Publication Name: Journal of Engineering Materials and Technology
Subject: Science and technology
ISSN: 0094-4289
Year: 2003
User Contributions:
Comment about this article or add new information about this topic:
On the improvement of calibration coefficient for hole-drilling integral method: part II-experimental validation of calibration coefficients
Article Abstract:
An improved three-dimensional FEM model was achieved using bending test of a cantilever beam resulted in an experimental validation of the calibration coefficients for integral hole-drilling method. The probability bounds are calculated by using calibration coefficient obtained from three-dimensional and two-dimensional model, to reveal the improvement of the calibration coefficients on the relieved stress calculation.
Publication Name: Journal of Engineering Materials and Technology
Subject: Science and technology
ISSN: 0094-4289
Year: 2003
User Contributions:
Comment about this article or add new information about this topic:
Evaluation of tensile strength of multistrand conductors - Part II: Experimental results
Article Abstract:
The results of tension-torsion measurements made with applied strain on aluminium conductor steel reinforced (ACSR), aluminium alloy conductor steel reinforced (AACSR) alloy conductors, were compared with a predictive model based on mechanical properties of the wires and geometry of a multistrand cable. Accurate predictions of true tensile strength of each cable were provided.
Publication Name: Journal of Engineering Materials and Technology
Subject: Science and technology
ISSN: 0094-4289
Year: 1998
User Contributions:
Comment about this article or add new information about this topic:
- Abstracts: Structural analysis of continuous contracts in technological trade using numerical simulation. Managing CFD simulation: reflections around a questionnaire
- Abstracts: Education for an environmental job. EPA's environmental monitoring methods index. Chelyabinsk: environmental affairs in a Russian city
- Abstracts: Freezing characteristics along a horizontal cooled tube immersed in aqueous binary solution with main flow. Test machine and control system interactions in the evaluation of rate-independent metal flow
- Abstracts: Comparative investment strategies in training and technology. Technology, globalization and defence: military electronics strategies in a changing world
- Abstracts: Notre Dame completes main building renovation. Here's the list, check it twice. Here is the church, here is the -- watch out!